Making Your Own Solar Panels
Mike Davis decided he wanted to practice his hobby away from the pollution of cities so he bought land in a remote area of Arizona. He is an astronomer and wanted a wonderful view of the stars. There was a problem however, no electricity. But Mike is a resourceful fellow. He built some homemade solar panels using inexpensive blemished and damaged solar cells he snapped up off eBay! Here is his story on how he did it:
"I bought a couple of bricks of 3 X 6 mono-crystalline solar cells. It takes a total of 36 of these type solar cells wired in series to make a panel. Each cell produces about 1/2 Volt. 36 in series would give about 18 volts which would be good for charging 12 volt batteries. (Yes, you really need that high a Voltage to effectively charge 12 Volt batteries) This type of solar cell is as thin as paper and as brittle and fragile as glass."
"A solar panel is really just a shallow box. So I started out by building myself a shallow box. I made the box shallow so the sides wouldn't shade the solar cells when the sun comes at an angle from the sides. Next I cut two pieces of masonite peg-board to fit inside the wells. These pieces of peg-board will be the substrates that each sub-panel will be built on. To protect the solar cells from the weather, the panel will have a plexiglass front."
"I laid out the cells on that grid pattern upside down so I could solder them together. All 18 cells on each half panel need to be soldered together in series, then both half panels need to be connected in series to get the desired voltage. I used a low-Wattage soldering iron and fine rosencore solder. I also used a rosen pen on the solder points on the back of the cells before soldering. Use a real light touch with the soldering iron. The cells are thin and delicate. If you push too hard, you will break the cells."
"In weak sun through clouds the half panel is producing 9.31 Volts. YAHOO! It works! Now all I had to do is build another one just like it. I drilled a hole in the back of the panel near the top for the wires to exit. Each solar panel in a solar power system needs a blocking diode in series with it to prevent the panel from discharging your batteries at night or during cloudy weather. I added a polarized two-pin jones plug to the end of the panel wires."
The finished product, producing 18.8 volts and 3.05 Amps in the sun. How much did it cost? Just over $100!
Not bad, though of course there's a lot of labor needed to actually build the thing, and you need the skills in the first place. Not a project for everybody, but those with the courage will certainly have a lot of fun. This is just a quick overview of the project. If you want more, please visit Mark's website linked below. There's a lot more details and more photos about how he built his inexpensive solar panels. Via How I built an electricity producing Solar Panel
In Sunday's Presidential radio address Obama announced that the US Department of Energy would commit $2 billion to two solar companies in an ongoing effort to build a clean energy economy.
Read More
A next generation wind turbine design offers the possibilty of generating up to three times the power from the current wind turbine design.
Read More
Exxon is planning a $600 million investment in biofuel through a strategic partnership with Synthetic Genomics to develop transportation fuels from algae.
Read More
T Boone Pickens scaled back his massive plans for a West Texas wind farm and will look to place wind turbins in other places in lesser quantities.
Read More
Congress is to open debate on a "clean energy" bill this week. Pressure has been steadily mounting from the Obama administration to show the world that Washington is serious about making a difference against global warming, .
Read More